C2-260 PCI/ISA Card Video Scaler is based on
TV One's exclusive CORIO2™ technology and provides
high quality Up-Conversion from standard video formats
(NTSC, PAL or SECAM) to Computer or HDTV signals.
It also handles Cross Conversion from any PC/HD signal
to any other. Video Inputs are 2x Composite, 2x YC (SVideo)
or 1x RGBHV, YUV or YPbPr Component. The
output is selectable as any computer resolution up to
2048x2048 at any vertical refresh rate and all HDTV
resolutions up to 1080p. A wide variety of computer
signal formats are available to support PC, Mac and
Workstation formats.
All the functions can be controlled via a Windows Control
Panel from the host PC via an RS-232 connection. An
Infrared Port is located on the card’s mounting plate and
an optional Remote Control Unit can be used for initial
setup of the unit. An OSD (On-Screen Display) is
provided to assist in setup. Most third party control
systems interface directly with the C2-260 as with the
entire C2 range of products.
Variable Zoom to 10X allows you to enlarge any part of
the video image to fill the entire computer screen and
position controls allow you to move around to any area
desired. Variable Shrink to as little as 10% allows the
image to fit onto most displays. The full bandwidth
chroma sampling insures faithfully reproduced, high
resolution colors.
The C2-260 also features a wide variety of additional
capabilities such as scaling of the RGB or YPbPr input,
Genlock, PIP, Chromakey, Lumakey and Mixing. The
Key Mode allows computer graphics to be keyed over
an external Composite or S-Video signal or vice versa.
The keyed image may be faded in and out. Due to the
4:4:4 sampling format, precise keying at the pixel level
can be achieved. The Mix Mode permits glitch-free
mixing between the computer image and external video.
The PIP Mode allows either of the video inputs to be inset in a window over the computer input.
Our exclusive AutoSet® feature takes the hassle out of
setup by automatically sizing and positioning the
computer image to fit exactly on the video screen. All
settings are stored in non-volatile memory and are
retained even when power is switched off.
Edge Blending is a standard feature of the C2-260.
Because of the ability to 'feather' any or all of the edges,
multiple images can be aligned vertically, horizontally, or
both to create unusual displays. Using multiple units,
there is no limit to the number of blended images. Edge
Blending is not limited to high resolution RGB computer
images, but can be applied to any input. Gamma
correction is employed to compensate for many of the
problems faced when blending between projectors.
Special preparation of the video in advance is not
necessary, since all processing is done within the unit. |
